Operation Manual

Technical Specifications A-9
Initialization Methods
The scanner can be initialized (returned to a fixed set of
conditions) in the following ways:
SCSI
USB
Hardware
initialization
The scanner is turned on.
The scanner receives a SCSI Reset signal
from the SCSI interface.
Software
initialization
Software sends the ESC @ (initialize the
scanner) command.
The scanner receives a SCSI Bus Device
Message.
Hardware
initialization
The scanner is turned on.
The USB cable is unplugged from the USB
port on the scanner.
Software
initialization
Software sends the ESC @ (initialize the
scanner) command.
The scanner receives a Bus Reset from the
USB interface.