Operation Manual

Selecting Change the Connection Methods
Follow the on-screen instructions until the following screen is displayed.
Select Set up Printer connection again (for new network router or changing USB to network, etc.) on the Install
Soware screen, and then click Next.
Changing the Network Connection to Ethernet from
the Control Panel
Follow the steps below to change the network connection to Ethernet from Wi-Fi using the control panel.
1. Select Settings on the home screen.
2.
Select General Settings > Network Settings > Wi r e d L A N S e t u p .
3. Tap Start Setup.
4. Check the message, and then close the screen.
e screen automatically closes aer a specic length of time.
5. Connect the printer to a router using an Ethernet cable.
User's Guide
Network Settings
47