Specifications

ES-800C
Operating
conditions:
Dimensions and
Width: 368 mm (14.5 inches)
weight:
Depth: 577 mm (22.5 inches)
Height: 161 mm (6.5 inches)
Weight: about 12 kg (26 lbs)
Electrical Specifications
Voltage:
Frequency:
Power
consumption:
Insulation
resistance:
120 VAC, flO%
49.5 to 60.5 Hz
Approx. 50 W (max)
20 m between AC power line and
chassis at 500 VDC
Environmental Conditions
Temperature:
Humidity:
Operation: 40” F to 95” F (5” C to 35” C)
Storage: 10’ F to 150” F (-20” C to 60” C)
Operation: 30% to SO%, without
condensation
Storage: 20% to 85%, without
condensation
Ordinary office or home conditions.
Extreme dust should be avoided.
Operation under direct sunlight
or near a strong light source should be
avoided.
Note:
Specijcations are subject to change without notice.
Parallel Interface Specifications
Interface type:
Bidirectional parallel interface
Data format: S-bit parallel
Synchronization: By external strobe pulse
Handshaking: By ACKNLG and BUSY signals
Logic level: Input/output data and interface control
signals are TTL level compatible
Connector type: 36-pin Centronics@ type connector
Connector pin
arrangement:
18
36
SCSI Specifications
Interface type:
Function:
ANSI X3.131-1986 standard
The following functions are included.
BUS FREE phase
ARBITRATION phase
SELECTION/ RESELECTION phase
COMMAND phase
(Logical Unit number is fixed to 0 and
command link function is not supported.)
DATA phase
Data in phase
Data out phase
STATUS phase
MESSAGE phase
(Includes MESSAGE IN phase and
MESSAGE OUT phase)
ATTENTION condition
RESET condition
Logic level:
TTL level compatible
Electrical standard: As per ANSI X3.131-1986
ID Setting:
Selectable from 0 to 7 with the rotary
switch.
(8 and 9 should not be selected.)
Connector type:
Two 50-pin connectors
Scanning Functions
Scanner settings
The table below summarizes the scanner functions and the
settings available on your scanner. All of these functions are
controlled by the software commands from your scanner
software.
Function
Resolution
Size
Available settings
23 settings from 50 to 800 dpi
50% to 200% at 1% step
Color line sequence mode, color page sequence
mode and monochrome mode (dropout color
4 dither patterns
Gamma correction
5 settings for output devices
Color correction
4 settings for output devices
ES-800C-2 11/2/92
Scanners