User`s guide

Appendix A:Scanner and Printer Specific Features
82 - ScanShop User’s Guide
• Manual
This will be the selection indicated if you manually drag the resize handles
of the image icon on the left side of the Print Controls window, or if you enter
values in the numeric fields. The units for entered values can be selected as
Inches or Millimeters.
Lock X & Y Scale
This check box control (on by default) will keep your manual scaling applied
equally to the height and width of your image when it is selected. If you uncheck
it, then your manual scalings will not necessarily be symmetric. In other words,
your image may look squashed or stretched.
Use Whole Page
This control (off by default) will allow you to position part or all of your image
upon the non-printing border area of the printer's page. Normally, these areas are
protected, and no part of the image may be placed within them.
However, sometimes you may want to print a full page image that was scanned
at the same DPI as the printer (for example, with Printer's Native Resolution
selected for Image Size). Turning on the Use Whole Page option allows you to
position the image over the non-printing border area. Note that clipping will
occur.
Almost all printers have some non-printable border area, and ScanShop takes this
area into account for each printer supported.
Paper Tray
This control allows you to select between different paper sizes available. In
particular, you will be able to select between using a full sheet of paper and a half
sheet of paper.
X0, Y0, Width, Height
The print size may also be set manually, either by dragging a rectangle in the
print preview area or by entering the settings directly into the X0, Y0, Width, and
Height text fields. The setting units may be specified as Inches or Millimeters.