User`s guide

Chapter 7:The Printer Set-up Window
ScanShop User’s Guide - 57
• Manual
This will be the selection indicated if you manually drag the resize handles
of the image icon on the left side of the Printer Set-up window, or if you enter
values in the numeric fields. The units for entered values can be selected as
Inches or Millimeters.
Lock X & Y Scale
This check box control (on by default) will keep your manual scaling settings
applied equally to the height and width of your image when it is selected. If you
uncheck it, then your manual scalings will not necessarily be symmetric. In other
words, you will be able to print your image in a squashed or stretched fashion.
Use Whole Page
The Use Whole Page Control (off by default) will allow you to position part or
all of your image upon the non-printing border area of the printer’s page.
Normally, these areas are protected, and all of your image will be printed.
However, sometimes you may want to print a full page image that was scanned
at the same dpi as the printer with Printer’s Native Resolution, so clipping will
occur. Almost all printers have some non-printable border area. ScanShop takes
account of these non-printable areas; they are programmed for every printer
supported.
Center X and Center Y
These controls will position the image so that it is perfectly centered on the page
when it is printed. Their effect is just like dragging the entire image selection box
from its center.
Options
Options pops up a dialog which gives you access to the extended imaging
features of your printer. To activate an option, click on the applicable button box.
Please refer to another section, “Scanner and Printer Specific Features” on
page 59 for more information about your printer’s extended features.