User`s guide

Chapter 4:Starting Up ScanShop
ScanShop User’s Guide - 27
-feeder=xfeed:yfeed
Enable automatic document feeding of custom page size xfeed by yfeed.
A suffix of
m, i, t, or p on xfeed or yfeed specifies units, otherwise
twelfths, (1/1200 in), is assumed.
-xfeed=n
See above.
-yfeed=n
See above.
-double
Scan in duplex or double sided mode on duplex scanners..
-compress=n
Perform compression on the image data, using compression hardware in
the scanner, if available. Use in conjunction with “
format=0” (tiff
format). These values are read in from (any and/or all of) the .scanshoprc
file, the ifs file, and the command line. They are then used for scanning
and finally written out to an ofs file (when specified).
-swcompress=n
Override use of image compression hardware; always use software
image compression. (Default value is 0, indicating that hardware
compression will be used when the scanner has this ability.)
-contrast=n
Sets level of contrast used during scanning to n.
Table 3:
=n option
Compression Type
0
none
1
g3.1
2
g3.2
3
g4.2
5
lzw
6
packbits