User`s guide

Appendix A:Scanner and Printer Specific Features
ScanShop User’s Guide - 105
Sensitometry Table
These radio buttons allow you to choose from the current sensitometry table in
the printer, 1 to 1 (“linear”), CIO paper, or upload a new table to the printer. Your
printer’s configuration will be automatically sensed, so that the treatment choices
available in this menu will depend on the printer selected and its output media.
In the XLS-8600 and 8650 Options GUI, a Kodak TableMaker file, also referred
to as a .TBL or PTF file can be downloaded to the printer. See also the ptf_file
command line option (which applies to the 77XX and the 86XX models).
Brightness
The brightness slider bar varies the brightness of the image, ranging from darkest
on the left to lightest on the right. (77XX models only)
Sharpness
Five levels of sharpness are available in the 77XX models, three levels in the
86XX models. Select the desired degree of sharpness by clicking on the
corresponding control.
Density
This control lets you choose the desired printer output density. (77XX models
only)
Reduction Filter
The reduction filter, when enabled, acts as a low-pass filter, slightly blurring the
image, so that if the image is printed at a lower resolution than it was scanned at,
there is less of a chance that very fine lines will be lost. (77XX models only)
Mirror
This option allows you to do a scan which mirrors the image over a vertical axis
down the center of the image, thus reversing the image left-to-right. Note that in
portrait mode, this axis cuts through the narrower sides, while in landscape
mode, it cuts through the wider sides.