User`s guide

Appendix A:Scanner and Printer Specific Features

ScanShop User’s Guide - 103

Use Whole Page

This control (off by default) will allow you to position part or all of your image

upon the non-printing border area of the printer’s page. Normally, these areas are

protected, and no part of the image may be placed within them.

However, sometimes you may want to print a full page image that was scanned

at the same DPI as the printer (for example, with Printer’s Native Resolution

selected for Image Size). Turning on the Use Whole Page option allows you to

position the image over the non-printing border area. Note that clipping will

occur.

Almost all printers have some non-printable border area, and ScanShop takes this

area into account for each printer supported.

X0, Y0, Width, Height

The print size may also be set manually, either by dragging a rectangle in the

print preview area or by entering the settings directly into the X0, Y0, Width, and

Height text ﬁelds. The setting units may be speciﬁed as Inches or Millimeters.

Center X and Center Y

These controls will position the image so that it is centered on the page, either

horizontally or vertically, when it is printed. Their effect is just like clicking on

the center of the image selection box and dragging it until it has been centered in

the appropriate direction.