User manual

Page 10 of 79
1 Introduction
This documents describes the steps to set up and configure epoScan.
To operate the scanning software refer to the ePhoenix Document Capture manual.
1.1 Audience
The intended audience is people need to know the installation and configuration parameters of
epoScan. These people must
• understand the concepts of paths and directories
• know the names and pathname locations of servers and items on servers
• be able to follow the instructions in this document and successfully install and configure a
default version of epoScan that matches their local environment.
There are some descriptions of advanced options included so that specialists can modify how
epoScan is configured. The audience for this is
• analysts
• developers
• systems administrators.
Note:
Only those sufficiently qualified and experienced should attempt to use the advanced
options to modify the default installation and configuration settings.
1.2 Overview
This document has the following general structure:
• chapter 2 gives general information
• chapter 3 covers the epoScan installation
• chapter 4 covers database installation
• chapter 5 is the scanning database installation decision chart
• chapter 6 describes the group 1 path
• chapter 7 describes the group 2 paths
• chapter 8 covers logging in
• chapter 9 describes the epoScan initial screen
• chapter 10 covers Batch
• chapter 11 covers Setup
• chapter 12 covers Admin.
• chapter 13 describes the database batch status