User Setup Information

q 8MB of system RAM; 4MB of application RAM
0 At least 100MB of hard disk space for scanner applications
and images, depending on the size of the images
0 A color monitor (one with a 24-bit video card is
recommended).
Setting Up the Scanner
Follow these steps to set up the scanner:
1. Take the scanner out of its box and place it on a flat, stable
surface with the rear panel facing you.
2. Remove the tape securing the scanner cover and pull out
the paper underneath the cover.
3. Locate the round knob in the middle of the rear panel.
4.
Turn the knob counterclockwise. If necessary, use a coin to
loosen it. The knob has a built-in spring, so it pops out a
little when released. You cannot remove the knob.
2 Getting Started