User's Manual

Option Card Problems

If you install an option card and get unexpected results, check the

following questions:

Is the option card installed correctly?

Did you follow the setup and operation procedures in the option card

instructions?

Did you set any necessary DIP switches or jumpers on the option

card? See your option card instructions.

Did you set any necessary DIP switches in the main unit? See “Setting

the DIP Switches” in Chapter

If you added an external device, did you use the proper cable to con-

nect the peripheral to the port or option card connector on the rear

panel?

Did you perform any necessary post-installation setup procedures for

the operating system? See your diagnostics, MS-DOS, or other soft-

ware manual for instructions.