User's Manual

To connect a printer to the main unit, you need an IBM PC AT-
compatible printer cable. If you are not sure which one you need, consult
your Epson dealer. Once you have a printer cable, follow these steps to
connect your printer to the parallel interface on the main unit:
1.
Place the printer next to your system, as shown in Figure 1-8.
Figure 1-8. Placing the printer
2.
Before you connect the printer, be sure the power switches on both
the main unit and the monitor are off.
3.
One end of the printer cable has a 25-pin male D-connector. (Refer to
your printer manual to determine which end this is.) Connect this
end to the socket marked PRINTER on the back panel of the main
unit. If the plug has retaining screws, tighten them with a small
screwdriver.
4.
Connect the other end of the cable to the printer. To secure the cable,
tighten the squeeze locks at each side of the printer port and push
them into the connectors on each side of the cable. Figure 1-9 shows
how to connect the cable to the printer.
14