User`s guide

EPSON
EPSON AMERICA INC.
SERVICE DEPARTMENT
PRODUCT SUPPORT BULLETIN
DATE: 3/9/88
NUMBER: S-0014A
SUBJECT: MS-DOS 3.2 FOR THE EQUITY I/II/III
The purpose of this bulletin is to
provide information
on the
availability of
MS-DOS 3.2 for Equity I, Equity II and Equity III
systems. Also included are instructions for
installing MS-DOS 3.2
on hard drive systems currently using earlier revisions of MS-DOS.
The Equity I+ MS-DOS 3.2 package has been
certified for
use with
the Equity I, Equity II
and Equity III.
This software is now
available for customers who wish to upgrade their system.
It can be ordered under Product Code Q390A-AA -
$85.00 retail.
This
package
includes MS-DOS 3.2/GW-BASIC
software with
documentation for the Equity I+.
The following is a simple procedure to perform the transfer of the
new MS-DOS 3.2 files to an existing hard disk system.
1. Insert the MS-DOS 3.2 diskette into drive A.
2. If the system is powered up, press RESET. If not,
turn the
system on.
3. At the A> prompt, type SYS C: and press ENTER. The system
will respond with the message, SYSTEM TRANSFERRED.
4. At the A> prompt, type REPLACE A:\*.* C:\ /S and press ENTER.
This will replace the existing MS-DOS files with version 3.2
files.
5. At the A> prompt, type REPLACE A:\*.* C:\[path] /A and press
ENTER.
This will copy new MS-DOS files to the subdirectory
indicated by [path].
6. Remove the MS-DOS diskette and insert the GW-BASIC diskette
into drive A.
7. At the A> prompt, type C: and press ENTER.
8. Repeat steps 4 and 5 above. (Prompt, listed in steps 4 and
5 as A>, will now be C>.)
9. Remove the GW-BASIC diskette from the drive. Put the
original diskettes in a safe place for storage.
Page 1 of 1