Specifications

PSB No: S-0127
Page: 2 of 2
INSTALLING THE INTERFACE CABLE
1: Remove the sub-assembly chassis from the computer and turn it over. Position it
so the hard disk drive is on the left.
2: Lay the interface cable on the sub-assembly so the drive connector is on the left
and the board connector is facing downward.
3: Connect the cable to the HDD.
4: Place a tie wrap fastener around the folded cables near the 90 degree fold.
5: Peel the backing off of the tie wrap fastener, and stick it to the bottom of the sub-
assembly chassis.
6: Re-install the sub-assembly.