Specifications

4-6
Troubleshooting
Tractor is selected as the
paper source on the control
panel.
Select Manual/CSF as the paper
source on the control panel. (See
“Buttons and Lights” on page 3-1.)
The platen rotates but the printer does not feed the paper.
Cause What to do
Tractor is selected as the
paper source on the control
panel.
Select Manual/CSF as the paper
source on the control panel. (See
“Buttons and Lights” on page 3-1.)
Paper feeding is crooked or the paper jams.
Cause What to do
The paper guide is not
properly installed.
Remove the paper guide and install it
as described in
“
Attaching the paper
guide” in the Setup Guide.
The edge guide is not
positioned correctly.
Move the edge guide so that they
match the width of your paper.
You may not be using the
right type of paper for the
printer.
Be sure you’re using the right type of
paper. See “Paper” on page A-10.
The paper is old or creased. Use only new, clean sheets of paper.
Note:
If paper is jammed in the paper path,
see “Clearing a Paper Jam” on page
4-26.