Specifications

3-12
Control Panel
Manual feed wait time
This setting allows you to set the amount of wait time between
when paper is inserted into the paper guide and it is fed. If the
paper feeds before you can adjust its position properly, you
should increase the wait time.
Buzzer (beeper)
The printer beeps when an error occurs. See “Using the Error
Indicators” on page 4-2 for more information on printer errors. If
you do not want the printer to beep when an error occurs, turn
off this setting.
Overlapping forms
This setting takes effect only when the skip-over-perforation
setting is on. When overlapping-forms setting is on, the printer
lifts up the print head each time it makes a one-inch margin with
the skip-over-perforation feature. You need to turn on both the
overlapping-forms and the skip-over-perforation settings when
you use overlapping forms.
Changing default settings
Follow these steps to enter the default-setting mode and change
the printer’s default settings:
Note:
❏
To print the language selection and default-setting mode
instructions, you need three sheets of A4 or letter size single-sheet
paper or three pages of continuous paper that is at least 279 mm (11
inches) long and 210 mm (8.3 inches) wide. See “Loading
Continuous Paper” on page 1-7 and “Loading Single Sheets” on
page 1-18 for instructions on loading continuous paper and single
sheets.
❏
If you use single sheets, you need to load a new sheet of paper each
time the printer ejects a printed sheet from the paper guide.