Specifications

A-22
Product Information
1. the top of overlapping form
2. the bottom edge of overlapping form
3. label
4. perforation
5. backing sheet
6. the bottom edge of the glue point area
❏
The label on your form should be placed within the shaded
area above, but not on the vertical or horizontal perforation.
Area measurements
A 17 ± 3 mm (0.51 ± 0.12 inch)
B 62.5 mm (2.46 inches) or more
C 4.2 mm (0.165 inch) or less
D thickness of area where label is attached:
0.53 mm (0.02 inch) or less
E from perforation to the top of the next overlapping form:
3.3 mm (0.13 inch) or more
F from perforation to the bottom edge of the glue point area:
17 mm (0.67 inch) or less
G from perforation to the bottom edge of the previous
overlapping form 13.3 mm (0.52 inch) or less
H total thickness including glue point dilation:
0.7 mm (0.028 inch) or less