Specifications

5-12
Options and Consumables
The cut-sheet feeder feeds paper when you send data to the
printer. You can also feed paper by pressing the Load/Eject
button.
Note:
❏
If the platen turns without loading the paper, completely remove the
paper and then insert it all the way into the printer again.
❏
If you need to adjust the position of the paper after it is loaded, see
“Adjusting the top-of-form position” on page 1-39 and follow the
instructions.
Loading paper manually using the paper guide
The cut-sheet feeder’s single-sheet loading feature allows you to
switch to a different type or size of paper without replacing the
paper already loaded in the cut-sheet feeder or removing the
feeder.
Follow these steps to load paper manually using the paper guide:
1. Make sure that Manual/CSF is selected as the paper source
on the control panel. If not, select it by pressing the Paper
Source button.
2. Push the paper guide and the paper guide extension all the
way in.
3. Adjust the edge guide so that it is aligned with the guide mark
on the paper guide.
4. While aligning the left side of paper with the edge guide,
insert it until it meets resistance. Be sure to load paper
printable side up. After a few seconds, the printer
automatically advances the paper to the loading position. The
printer is ready to accept data from your computer and print.