User's Guide

1. Set the connection mode switch on the scanner to Wi-Fi.
2. Open the input tray and turn on the scanner.
3. Press and hold the Connect button on the scanner for at least 3 seconds, then release it when the
Status and ! error lights flash alternately.
The scanner enters standby mode for WPS connection for two minutes.
4. Press the WPS button on your router or access point.
The Status light on the scanner stays on, indicating that the scanner is connected to the network.
5. Set up network scanning on your computer.
Parent topic: Wi-Fi Protected Setup (WPS)
Related tasks
Setting Up Network Scanning
Using WPS PIN Mode to Connect to a Network
If you have a WPS-enabled wireless router or access point that supports PIN mode, you can use Wi-Fi
Protected Setup (WPS) PIN mode to connect your scanner to the network.
42