User's Guide

3. Press and hold the Connect button for at least 3 seconds until the Status and ! error lights flash
alternately.
The scanner enters standby mode for WPS connection for two minutes.
4. Press the WPS button on your computer or device, or enable the WPS feature.
When the Status light on the scanner stays on, the connection is established.
Parent topic: Direct Wi-Fi Mode Setup
Wi-Fi Protected Setup (WPS)
If your network uses a WPS-enabled wireless router or access point, you can quickly connect your
scanner to the network using Wi-Fi Protected Setup (WPS).
Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router or access
point. If there is no hardware button, there may be a virtual WPS button in the software for the device.
Check your network product documentation for details.
Using WPS to Connect to a Network
Using WPS PIN Mode to Connect to a Network
Parent topic: Wi-Fi Networking
Using WPS to Connect to a Network
If you have a WPS-enabled wireless router or access point, you can use Wi-Fi Protected Setup (WPS) to
connect your scanner to the network.
41