Product Information Guide

EPSON Stylus Pro 9000 series
8/00 EPSON Stylus Pro 9000 series - 11
3. Press the
Item
button.
PAPER THICK=STD
appears on the
display.
If you’re using EPSON paper, leave this setting on
STD
.
If you’re using other media, enter the thickness value of the
paper in 0.1 mm increments by pressing the
+
or
−
button.
4. Press the
Enter
button to save the setting.
ADJUST.PATT.=ALL
appears on the display.
5. Press the
Enter
button to print the full series of alignment
patterns.
If you want to print a single alignment pattern, press the
+
or
−
button until the pattern number appears. Then press
the
Enter
button.
❏
For the EPSON Stylus Pro 9500, skip to the next
section, “Completing the Alignment Procedure.”
❏
For the EPSON Stylus Pro 9000, patterns 1 through 3
are printed on the first sheet of paper. After this sheet is
printed,
PAPER OUT
appears on the display and the
red
PAPER OUT
light comes on.
6. Raise the paper set lever and remove the printed sheet.
7. Load another sheet of paper. The next three patterns are
printed.
8. Repeat steps 6 and 7 twice, until all 12 patterns have been
printed.
9. Raise the paper set lever and remove the last printed sheet.
Then lower the lever and continue the alignment procedure
in the next section.
Completing the Alignment Procedure
After all the patterns have printed, continue with these steps.
1. Do one of the following:
❏
For the EPSON Stylus Pro 9000, examine pattern #1
and determine which row number has the smallest gaps.
In the first example below, the lines in row 4 have the
smallest gaps. In the second example, row 6 has the
smallest gaps.
❏
For the EPSON Stylus Pro 9500, examine row #1 and
determine which line or box number has the smallest
gaps. In the example below, line 8 has the smallest gaps
in row 1.
1
2
3
4
5
6
7
patterns #1-5, #7, #9-12
EPSON Stylus Pro 9000 Alignment Patterns
1
2
3
4
5
6
7
patterns #6, #8
EPSON Stylus Pro 9500 Alignment