Product Guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap1-Connecting Your Printer and Installing Drivers
- Chap 2-Handling Paper
- Chap 3-Printing with EPSON Drivers for Macintosh
- Chap 4-Printing with EPSON Drivers for Windows
- Chap 5-Monitoring the Printer
- Chap 6-Maintaining and Transporting the Printer
- Running a Cleaning Cycle
- Aligning the Print Head
- Running the Print Head Alignment Utility
- Replacing Ink Cartridges
- Replacing the Paper Cutter Blade
- Running the Speed and Progress Utility for Improved Windows Printing
- Cleaning the Printer
- Transporting the Printer
- Replacing the Waste Ink System
- Diagnosing Problems
- Chap 7-Resolving Problems
- Chap 8-Specifications
- Appendix A-Configuring the Printer
- Index
2-17
Handling Paper | 2-17
Make sure the right edge is straight. It should be aligned with the scale
on the roll paper cover (at the top) and the two rows of holes (at the
bottom).
6. Pull the paper set lever all the way up, then close the lower cover.
PRESS PAUSE BUTTON
appears on the control panel display.
7. Press the
Pause
button. The print head moves and the paper feeds into
printing position automatically.
READY
appears on the control panel.
(Even if you don’t press
Pause
, the paper and printer will move into
printing position automatically after 10 seconds.)
8. Print your page. After it is finished, the page stays in the printer.
9. To remove your printout, hold it while pressing the
Paper Feed (–)
button.
Caution
To avoid damaging the
printer, never move the
paper set lever while the
Operate or Pause light is
flashing.