Product Guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap1-Connecting Your Printer and Installing Drivers
- Chap 2-Handling Paper
- Chap 3-Printing with EPSON Drivers for Macintosh
- Chap 4-Printing with EPSON Drivers for Windows
- Chap 5-Monitoring the Printer
- Chap 6-Maintaining and Transporting the Printer
- Running a Cleaning Cycle
- Aligning the Print Head
- Running the Print Head Alignment Utility
- Replacing Ink Cartridges
- Replacing the Paper Cutter Blade
- Running the Speed and Progress Utility for Improved Windows Printing
- Cleaning the Printer
- Transporting the Printer
- Replacing the Waste Ink System
- Diagnosing Problems
- Chap 7-Resolving Problems
- Chap 8-Specifications
- Appendix A-Configuring the Printer
- Index
iv
FCC Compliance Statement
For United States Users
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio or television
reception. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio and television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING
The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC
Certification of this device and may cause interference levels which exceed the limits established by the FCC for
this equipment. It is the responsibility of the user to obtain and use a shielded equipment interface cable with this
device. If this equipment has more than one interface connector, do not leave cables connected to unused
interfaces. Changes or modifications not expressly approved by the manufacturer could void the user’s authority to
operate the equipment.
For Canadian Users
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le materiel brouilleur du Canada.