Product Guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap1-Connecting Your Printer and Installing Drivers
- Chap 2-Handling Paper
- Chap 3-Printing with EPSON Drivers for Macintosh
- Chap 4-Printing with EPSON Drivers for Windows
- Chap 5-Monitoring the Printer
- Chap 6-Maintaining and Transporting the Printer
- Running a Cleaning Cycle
- Aligning the Print Head
- Running the Print Head Alignment Utility
- Replacing Ink Cartridges
- Replacing the Paper Cutter Blade
- Running the Speed and Progress Utility for Improved Windows Printing
- Cleaning the Printer
- Transporting the Printer
- Replacing the Waste Ink System
- Diagnosing Problems
- Chap 7-Resolving Problems
- Chap 8-Specifications
- Appendix A-Configuring the Printer
- Index
1-3
Connecting Your Printer and Installing Drivers | 1-3
3. Make sure you set any jumpers or DIP switches on the card. See the
card’s documentation for details.
On the FireWire card, make sure DIP switch 10 is set to
ON
(advanced
mode).
4. Slide the interface card along the slots on both sides of the
compartment. Push it in firmly to fully insert the connector into the
printer’s internal socket.
5. Secure the interface card in the slot with the two screws included with
the card.
6. Make sure the printer has been turned off using the
Power
button.
Then plug in the power cord.
7. To initialize the EpsonNet Internal Print Server, turn on the printer
while holding down the status sheet button on the card for about 5
seconds.