Product Guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap1-Connecting Your Printer and Installing Drivers
- Chap 2-Handling Paper
- Chap 3-Printing with EPSON Drivers for Macintosh
- Chap 4-Printing with EPSON Drivers for Windows
- Chap 5-Monitoring the Printer
- Chap 6-Maintaining and Transporting the Printer
- Running a Cleaning Cycle
- Aligning the Print Head
- Running the Print Head Alignment Utility
- Replacing Ink Cartridges
- Replacing the Paper Cutter Blade
- Running the Speed and Progress Utility for Improved Windows Printing
- Cleaning the Printer
- Transporting the Printer
- Replacing the Waste Ink System
- Diagnosing Problems
- Chap 7-Resolving Problems
- Chap 8-Specifications
- Appendix A-Configuring the Printer
- Index
7-10
7-10 | Resolving Problems
•
Make sure the printer is not located in a brightly lit area. The paper
sensor may not be able to operate correctly.
•
Make sure the
Print Mode
or
Media Type
setting is correct for the
media you’re printing on.
•
Make sure the platen gap setting is correct for the paper or media you’re
printing on. See page 2-18 for more information.
•
If you’re not using EPSON media, make sure you register and select
your paper’s thickness. See page 2-21 for more information.
Solving Roll Paper Ejection Problems
If you are using the printer without the stand, tightly wound roll paper may
feed out with a curl. Extend the paper guides as shown below: