Quick Installation Guide

Assigning a Static IP Address | 5
Installing the Server Software
Follow the instructions in this section to install the software on the server.
They describe how to:
• Assign a static IP address (see below)
• Name the server (see page 6)
• Install the Fiery Spark Server software (see page 6)
• Connect the hardware key (page 7)
• Install Command WorkStation
™
(see page 8)
• Install ColorWise Pro Tools (optional, see page 11)
Before you begin, make sure you have:
• Installed the EPSON printer driver (see your EPSON printer
documentation for instructions)
• Connected the printer to the server using the USB interface (Stylus Pro
7600 and 9600) or the FireWire IEEE 1394 interface (Stylus Pro 10000
and 10600)
• Closed all open programs and turned off any virus protection programs
Assigning a Static IP Address
1. Right-click
My Network Places.
2. Select
Properties.
3. Right-click
Local Area Connection.
4. Select
Properties.
5. Double-click
Internet Protocol (TCP/IP).
If the server is using a DHCP connection, skip ahead to “Naming the
Server” on page 6.