Product Information Guide

Epson Stylus Photo RX700
5/05 Epson Stylus Photo RX700 - 9
Placing 35-mm Film Strips in the Holder
1. Remove the film strip cover.
2. Slide your film strip into the holder.
Note:
The photos should be mirror-imaged when viewed from
overhead. (The shinier side of the film faces down; the duller side
faces up.)
3. Replace the film strip cover.
4. Fit the holder’s tabs into the two small holes at the rear edge
of the glass. Make sure the film strip is in the middle of the
glass (not at the rear edge) to align it with the fluorescent
lamp when you close the lid.
Continue with the steps in the next section to scan and print
your photos.
Scanning and Printing Your Photos
1. Close the scanner lid.
2. Press the
Slides Negatives button. You see the screen
below.
Note:
Do not press the Copy button, or the film holder will be scanned
instead of the film.
3. Select Custom Print, then press OK. You see this screen:
4. Select
Photo(Single), then press OK.
5. On the next screen, use the u, d, l, r arrow buttons to
select basic print settings. Press
OK when done making your
settings.
❏
Paper Type: Select the setting for the type of paper
you’ve loaded (see page 7).
❏
Paper Size: Select the size of paper you’ve loaded.
❏
Layout: If you want to print without white borders
around the edges, choose
Borderless. Otherwise
choose
with Border.
❏
Restoration: Turn on to restore color to faded slides or
negatives (see page 10).
Film strip is in
middle of glass
Fluorescent lamp