Quick Reference Guide

32 Maintaining Your All-in-One
Cleaning the Print Head
If print quality has declined and the nozzle check indicates clogged nozzles, you
can clean the print head. Print head cleaning uses ink, so clean it only if necessary.
Note:
You cannot clean the print head if an ink cartridge is expended, and may not be able to
clean it when a cartridge is low. You must replace the cartridge first (see page 35).
1. Load letter-size paper in the rear sheet feeder.
2. Press the
Setup button.
3. Select
Maintenance and press OK.
4. Select
Head Cleaning and press OK.
5. Press x
Start.
Cleaning lasts around 1 minute. When it’s finished, you see a message on the
display screen.
Caution:
Never turn off the RX680 Series during a cleaning cycle or you may damage it.
6. Press x Start to run a nozzle check and confirm that the print head is clean.
Note:
If you don’t see any improvement after cleaning the print head three times, turn off your
all-in-one and wait at least six hours to let any dried ink soften. Then try printing again.
If you do not use your all-in-one often, it is a good idea to print a few pages at least once
a month to maintain good print quality.
sprx680_qg.book Page 32 Wednesday, June 6, 2007 8:40 AM