Quick Reference Guide

Maintaining Your All-in-One 31
Maintaining Your All-in-One
Follow the steps here to check and clean the print head, and replace ink cartridges.
To align the print head, if necessary, see your on-screen User’s Guide.
You can also perform these maintenance tasks through your RX680 Series
software. See your on-screen User’s Guide for instructions.
Note:
If you need to clean the document cover, use only a soft, non-abrasive microfiber-type
cloth.
Checking the Print Head Nozzles
If your printouts are faint or have gaps in them, the print head nozzles may be
clogged or ink may be running low in an ink cartridge. Follow these steps to check
the print head nozzles:
1. Load letter-size paper in the rear sheet feeder.
2. Press the
Setup button.
3. Select
Maintenance and press OK.
4. Select
Nozzle Check and press OK.
5. Press x
Start.
6. Check the nozzle check pattern that prints to see if there are gaps in the lines.
7. If there are no gaps, press
OK to continue printing.
If there are gaps or the pattern is faint, press x
Start to clean the print head.
Nozzles
are clean
Nozzles need
cleaning
sprx680_qg.book Page 31 Wednesday, June 6, 2007 8:40 AM