User's Guide

● You must use a Category 5 shielded twisted-pair cable to connect the
Network Image Express Card to prevent a malfunction.
● Do not connect the Network Image Express Card directly to a computer;
connect it only to a network hub.
● Do not connect or disconnect the network cable when the scanner is
turned on.
● To use the Network Image Express Card, disconnect the USB cable from
the scanner; otherwise the scanner may not work properly.
● Do not disconnect the USB cable while an Ethernet cable is already
connected to the RJ-45 connector on the Network Image Express Card.
Turn on the
scanner.
Check the lights on the Network Image Express Card. Initialization is in progress while
the red status light and the green data light are on. When the yellow status light
comes on, initialization is complete. When the red status light is on and the green data
light is flashing, the card is receiving data.