User's Manual

Installing Options 4-13
Note:
You can match the printer’s and computer’s baud rate or set the printer to
a higher baud rate than that supported by your computer (this may not work
with some computer systems).
* To change this setting, set the jumper and slide switch settings on the Serial
interface card or the LocalTalk/Serial module, as described on page 4-8.
You also need to set Windows to use a serial port with your
printer, as described in the next sections.
Setting Options
Serial type RS-232C, Current Loop*
Word length 7, 8
Baud rate 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600
Parity None, Even, Odd
Stop bit 1, 2
DTR On, Off
XON/XOFF
(Printer ready
protocol)
On, Off