User's Manual

Using the Control Panel 3-19
* If the font selected in the FontSource and Font Number settings is not
available in the SymSet you choose, the FontSource and Font Number
settings return to their default values.
** These menu items are available only when an optional font ROM module is
installed.
GL2 Menu
The GL2 menu controls the settings for the EPSON GL/2 mode,
which allows you to use your printer with plotter applications.
Within this emulation mode, you can choose between two
operational modes: LJ4GL2 and GLlike. For information about
GL/2 commands, see Chapter 4 in the Technical Infomation
manual.
The table below shows the principal differences between these
modes.
Form Sets the number of lines (5 to 128) for the selected
paper size and orientation, causing new line spacing
settings to be stored in the printer; changes to the
Page Size or Orientation settings in SelecType may
change the Form setting you select; 60 lines is the
default.
Source SymSet ** Selects the symbol set number for an optional font
ROM source (from 0 to 3199).
Dest SymSet ** Selects the symbol set number for an optional font
ROM destination (from 0 to 3199).
Command LJ4GL2 GLlike
Orientation Printer setting Landscape only
Plotter unit 1/1016 inch 1/1021 inch
Picture frame Same as LJ4 mode Depends on hard-clip
limit
Default positions of P1
and P2
Lower left and right
corners, respectively,
of picture frame
Inside picture frame
LJ4 menu items (continued)
Menu item Description