User's Manual

3-6 Using the Control Panel
OneTouch Mode Settings
The table below lists the options available for each OneTouch
mode setting. Default settings are shown in bold
type.
* Not all page sizes are supported by the Duplex Unit or the paper cassettes.
See Appendix A for details on which page sizes are supported by each of
the printer’s paper sources.
OneTouch mode setting options
Setting Options Description
Paper Source Auto
MP (built-in tray)
LC1 (lower cassette 1)
LC2 (lower cassette 2)
Selects the tray to load paper
from; Auto loads from the tray
containing paper that matches
the Page Size setting below
Page Size A3, A3+, A4, A5, B4, B5,
LT, B, HLT, LGL, GLT,
GLG, EXE, F4, MON,
C10, DL, C5, C6, IB5,
CTM *
Selects the page size of the
image to be produced
Manual Feed On
Off
Turns manual feed mode on or
off for the built-in paper tray;
see Chapter 1 for instructions
Orientation Portrait
Landscape
Selects the print direction on
the page
RITech Dark
Medium
Light
Off
Sets the RITech (Resolution
Improvement Technology)
setting for your print job; see
Chapter 5 for details
Copies 1 to 999 Selects the number of copies to
print
MP Tray Size A3, A3+, A4, A5, B4, B5,
LT, B, HLT, LGL, GLT,
GLG, EXE, F4, MON,
C10, DL, C5, C6, IB5, *
Selects the size of paper
loaded in the built-in paper tray
Toner Save On
Off
Sets the amount of toner used
in your print job; for draft
copies, set to On to use
approximately 50% less toner
for a lighter printout