Parts User Manual

3-2 Configuring the EPL-N2000 for AppleTalk
This chapter describes how to configure the EPL-N2000 from a
Macintosh computer using EPSON Net! for Macintosh.
Before configuring the EPL-N2000 on an AppleTalk network, do
the following:
❏ Install the optional EPSONScript Level 2 ROM module
(C832261). (See the instructions that came with your
module.)
❏ Install the EPSONScript driver for Macintosh. (Look for the
driver diskette in the box that the EPSONScript Level 2 ROM
module came in.)
❏ Make sure the EPL-N2000 is connected to the network. See
Chapter 1 for information on connecting the Ethernet
interface card.
EPSON Net! for Macintosh consists of two utilities: EPSON
Zoner and EPSON Namer. To set up the EPL-N2000 for an
AppleTalk network, you need to copy these two utilities to your
hard disk and rename the printer using EPSON Namer. If
necessary, you then assign a zone to the printer using EPSON
Zoner.
Note:
EPSON Zoner works only on an AppleTalk Phase II network.