User's Manual
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-SETTING UP
- CHAP 2-TESTING AND CONNECTING YOUR PRINTER
- CHAP 3-SELECTYPE
- CHAP 4-PAPER HANDLING
- CHAP 5-MAINTENANCE AND TRANSPORTATION
- CHAP 6-TROUBLSHOOTING
- CHAP 7-OPTIONS
- APPENDIX A-TECHNICAL SPECIFICATIONS
- APPENDIX B-HP EMULATION MODE
- APPENDIX C-LQ AND FX EMULATION MODE
- GLOSSARY
- INDEX
- QUICK REFERENCE
- PRINTER DIAGRAM
Memory Options
Checking the printer’s memory
Perform the following steps to verify that you installed the chip
sets properly and that the printer recognizes the memory:
1. Turn on the printer. You should then see the following:
l All indicator lights on the panel light briefly
l The ROM Check message appears.
2.
When the RAM Check x.xMB message appears, make sure the
printer displays the total amount of RAM that you now have
installed (including the 1MB of internal memory).
If an incorrect amount appears, turn off the printer and remove
the controller board. Make sure you installed each chip set in
the correct sector and that each chip is fully seated. If the
RAM check message is still incorrect, contact your dealer for
assistance.
7-36
Options