Product Information Guide

EPL-8000
3. Press the chip into the socket as described in steps 3 and 4 of
the previous section.
4. Set the board’s DIP switches to indicate the amount of memory
you have installed. Use a pointed object, such as a ball-point
pen, to set the DIP switches as shown below.
Set the switches according to the tables below.
RAM (~ntemal and amount added lo controller board1
pqqigjq
31
Installing the expansion board on the controller board
1. Locate connector chJ3 on the controller board. position the
memory expansion board as shown below, and carefully insert
its connector into connector CN3.
2. Secure the expansion board with the three screws that came
with it.
Reinstalling the controller board
1.
2.
5.
6
7.
Hold the controller board so the component side faces your
left, and fit its top and bottom edges into the grooves inside
the slot. Gently slide the board about halfway into the printer.
Make sure the lever on the bottom of the controller board is a11
the way down. As you slide the board further into the printer,
make sure the lever’s tab is positioned inside the opening in
the bracket. as shown below.
Now slide the controller board into the printer. The
lever pivots outward. Firmly press up on the lever to lock the
board into pIace.
If the controller board does not fit smoothly into the printer,
do not force it. Remove it and make sure the edges fit properly
into the grooves in the slot.
Gently press in on the baud to make sure it is fully seated.
Then secure the board with the four screws you removed
previously.
Replace the optional interface card, if you removed one
Connect any interface cables you removed.
Be sure the power is turned off and then plug the power cord
into the printer and into an electrical outlet.
Laser Printers ml92 EPL-8000-7