Product Information Guide
EPL-7000 LASER PRINTER
Durability:
5 years or 180,000 sheets (3,000 per month X
60 months); whichever comes first.
Data format
Electrical
Voltage:
Rated frequency
range:
120 V model: 90 to 132 VAC
50 Hz to 60 Hz ± 3Hz
Word length:
7 or 8 bits
Parity:
none, odd or even
Stop bits:
1 or 2
Printer ready protocol: enabled (DTR and XON/XOFF protocol
set to ON.)
Power consumption:
Less than 550 W
Insulation
2 MR minimum
resistance:
Dielectric strength (between AC line and
chassis):
120 V model can withstand 1500 VAC rms
for one minute or 1650 VAC rms for one
second.
Controller hardware
CPU
68000, 12.5 MHz
RAM
Standard: 0.5 MB (expandable up to 6 MB)
Environmental
Temperature:
Operation: 50° to 95° F
(10 to 35"
C)
Storage: 32° to 95° F (0° to 35° C)
Humidity:
Altitude:
Levelness:
Operation: 1.5 to 85 % RH
Storage: 30 to 85 % RH
8200 feet
(2500
meters) maximum
Should be kept level
Interface Specifications
Interface timing
The figure below shows the timing for the parallel interface.
The data format can be set using functions and menu options in
SelecType.
Baud rate
300, 600,
1200,
2400, 4800,
9600,
19,200 bits
per
second.
Signal level
RS-232C: Conforms to EIA
Handshaking
The printer’s serial interface can use DTR (Data Terminal Ready)
signal levels and XON/XOFF communication protocols either
separately or in combination. When the vacant area for data in the
input buffer drops to 128 bytes, the printer outputs an XOFF code
or sets the DTR signal level to low (MARK, indicating that it
cannot receive more data).
Once the vacant area for data in the buffer recovers to 256 bytes,
the printer outputs an XON code or sets the DTR flag to high
(SPACE), indicating that it is again ready to receive data.
Error handling
A l character is printed if a parity error, framing error, or over-run
error is detected.-
Connector
D-sub 25-pin connector
i-
\
Senal
Interface
Parallel
Interface
Signal level:
TTL compatible
Serial interface
The printer’s resident serial interface can be set for either RS-232C
or RS-422 operation. These interfaces have the following
characteristics.
Laser Printers
1/7/91 EPL-7000-3