Product Information Guide

EPL-7000 LASER PRINTER
AUTO CONT.
Automatic continue. Permits the printer to
continue printing instead of stopping under
certain error conditions.
1 to 99
BEEPER
Turns the beeper on or off.
P-CONFIG. SAVE
Printer configuration save. Saves all Level 2
settings as defaults so they take effect each
time you turn the printer on.
FACTORY RESET Returns all Level 1 and Level 2 settings to their
factory settings.
Use this option to print up to 99 copies of your print job. The
factory setting is 1. If you select a number above one, the display
keeps count of the number of copies completed and the current
setting. For example, if you set the copies option to 10 and 5
copies are complete, the display shows 5/10.
VERSION Displays the version numbers of the printer’s
firmware components such as the controller and
font.
Testing the Printer
Follow these steps to select and run the test print:
STANDBY
Conserves power by reducing power to the
fixing heater when the printer is not used for
30 minutes.
1. Hold down the SelecType button until the LEVEL 2 indicator light
goes on and TEST PRINT appears on the display.
This section lists all the options available when you use SelecType.
Most options are the same whether you’re working in L-JET2P,
LQ, or FX emulation mode. Some of the options in Level 1,
however, have a different function for each mode. These options
are listed later in this chapter. See the Quick Reference Card for a
map of all SelecType menus and options.
Level 1 options
When you press SelecType once to enter Level 1, one of the Level 1
main menu options listed below appears on the display.
If you have entered SelecType before, TEST PRINT may not be
the first option to appear. If the Level 2 indicator is on, you can
press the up or down arrow until TEST PRINT appears on the
display. Then go on to step 2.
If you did not hold down the button long enough to enter Level 2,
the LEVEL 1 indicator goes on. If this happens, press the SelecType
button once to exit SelecType and repeat step 1.
INPUT
P-SIZE
COPIES
ORIENT.
FONT
STATUSSHEET
SUB CONFIG.
SYSTEM CONFIG.
2. Press m once. The display reads as follows:
Each of these options is described below. An asterisk (*) indicates
the factory default setting for each option.
3. To run the test, press I,( once more. The printer prints a test
pattern of vertical lines and ejects the page face-down on top
of the printer.
CAUTION: Never open the printer cover during printing
Note: If you have set the MEMORY SHARE option in Level 2,
the display shows CH SELECT whenever you enter Level 1.
After you select the channel, one of the main menu options
listed above appears on the display.
Printing a Status Sheet
In addition to the test print patterns, you can print a status sheet
that lists printer settings for your selected channel.
OTHER
A4
A5
B5
* LETTER
HALF LT
LEGAL
GLT
GLG
EXE
F4
MONARCH
C10
DL
C5
(Half Letter)
(Government Letter)
(Government Legal)
(Executive)
(Commercial 10)
Note: The status sheet prints the printer’s current settings. If
you change the macro number setting for the LOAD MACRO
prints out the new macro settings. MACRO 0 is the factory
Follow these steps to print the status sheet:
1. Make sure that your printer is plugged in and the power is on.
2. Press SelecType once to enter SelecType Level 1.
YOU cm choose any of the paper sizes shown above with the
P-SIZE option. The factory setting is LETTER.
Laser Printers
1/7/91 EPL-7000-11