User's Manual

Error Messages
TONER EMPTY
The developer unit may not be installed properly. Open the printer
and make sure the developer unit is seated properly in the basket.
If the message remains, the toner is low and you must replace the
toner cartridge. See the section on replacing the toner cartridge in
Chapter 6.
CPU ERROR ERROR 30
ERROR 10
ERROR 31
ERROR 11
ERROR 32
ERROR 12
ERROR 33
If one of these error messages appears, follow the steps below.
1. Press the RESET/CONTINUE button.
2. If the error does not clear, turn the printer off for at least five
seconds. Then turn it back on.
3. If the problem remains, service is required. If you need service,
contact an authorized Epson dealer. If you need assistance
locating a dealer, call the Epson Consumer Information Center at
l-800-922-8911 for the location of the nearest Epson dealer.
7-6
Troubleshooting