Service manual

EPSON EPL-5800 Revision B
Disassembly and Assembly Disassembly Procedure 82
4. Remove the paper feed sensor (PS1). (one connector)
Figure 4-28. Paper Feed Sensor (PS1) Removal
4.2.19 High Voltage Unit (HV1) Removal
1. Remove the right cover, the left cover, and the rear cover.
2. Remove the power supply unit.
3. Remove the high voltage unit (HV1). (three screws, one connector)
NOTE:
When installing the high voltage unit (HV1), be careful at the following
points.
!
Install the earth plate at the rear of the high voltage unit as shown in the
Figure 1 in the Figure 4-29.
!
Make sure all the contact points (four points) are contacted.
Figure 4-29. High Voltage Unit (HV1) Removal
4121s065
4121s078
4121s066
4121s079
Figure 1
Earth
Plate
Contacting
Points