Service manual

EPSON EPL-5800 Revision B
Disassembly and Assembly Disassembly Procedure 80
9. Remove the roller assembly. (two screws)
10. Remove the fusing separation claws. (four claws)
11. Remove the thermistor (TH1). (one screw)
NOTE:
When installing the thermistor, let the harness through as shown in the
figure 1 of the Figure 4-24.
12. Remove the thermostat (TS1). (two screws)
Figure 4-24. Thermistor and Thermostat Removal
4.2.16 Interlock Switch (S2) Removal
1. Remove the right cover, the left cover, and the rear cover.
2. Remove the interlock switch (S2). (one screw, two connectors)
Figure 4-25. Interlock Switch (S2) Removal
Figure 1 Back of the Fusing Unit
4121s061
Thermistor
Fusing Separate Claw (4)
Thermostat
3704
4121s077
Roller Assy.
Roller Assy.
Harness
4121s062
Orange
Red
Interlock
Switch