Service manual

EPSON EPL-5800 Revision B
Disassembly and Assembly Disassembly Procedure 79
5. Remove the terminal board. (two screws)
6. Pull out the heater lamp.
Figure 4-22. Heater Lamp Removal
7. Remove the driven gear from the heat roller.
8. Shift the heat roller to the right side (1) and then shift it to (2) direction, and pull the
roller out toward (3) direction.
Figure 4-23. Drive Gear Removal
CAUTION
!
Do not touch the glass of the lamp with bare hands.
!
When installing the heater lamp, install it as the voltage indicator
faces the gear side.
4121s059
Voltage Indicator
3704
1305
Heater Lamp
CAUTION
To avoid scratching the heat roller surface by the fusing separation
claw, when removing or installing the roller, keep the fusing
separation claw lifted untouched.
4121s060
(1)
(2)
(3)