Service manual

EPSON EPL-5800 Revision B

Disassembly and Assembly Disassembly Procedure 71

4.2.3 Transfer Roller Replacement

Replace the transfer roller every about 50,000 sheets.

1. Use the mini driver and remove the transfer front cover. (two screws)

2. Push down the lever of the shaft supports (white) on the right and left of the transfer

roller toward the front, and remove the transfer roller from the transfer roller holder.

Figure 4-6. Transfer Roller Removal

3. Remove the right and left shaft supports and gear from the removed transfer roller, and

install them to the new transfer roller.

4. Insert the transfer roller to the transfer roller holder of the printer, and set the bearing

lever to the top.

Figure 4-7. Installing the Transfer Roller

5. Install the transfer front cover. (two screws)

CAUTION

Since the life span of the transfer roller and fusing unit are the

same, if you need to replace the transfer roller because of worn-

out etc., make sure to replace the fusing unit as well.

Do not touch the surface of the transfer roller nor stain it with

chemicals or toner, for the dents or dirt on the surface of the

transfer roller badly affects on the printing quality.

When handling the transfer roller, hold the shaft of the roller or

the shaft supports.

4121s043

Front Cover Transferring

Transfer Roller

Transfer Roller Holder

3907

4121s044

4121s044b

Transfer Roller Holder