Service manual

EPSON EPL-5800 Revision B
Product Description Control Panel 35
QUANTITY
This is the copy quantity setting when copying by quantity. This setting is specified
taking preference over the Copies setting. When the printing quantity is 2 or more, the
Copies setting will be 1.
This setting can be specified only with EJL or ESC/Page command and the setting
cannot be stored.
If data for 1 job data failed to be stored into printer, the warning “Collate was disabled”
will be displayed and the printer prints out only one quantity.
PARALLEL I/F, USB I/F, AUX I/F
Only interfaces that are set to “On” by the panel setting can be used by the automatic
selection.
All interfaces are set to “On” at the factory default setting.
When use a fixed interface, set “On” only for the interface that to be used.
Changes to the interface setting will be effective after the Reset All is performed or the
power is turned on again.
If “Off” is set to all interfaces, they are reset to “On” after the Reset All is performed or
the power is turned on again. (It is not allowed to set “Off” to all interfaces.)
#
: On, X: Off
Table 1-23. Interface Settings
Parallel USB Type B Operations
Using Fixed I/F
#
X X Only parallel can be used.
X
#
X Only USB can be used
XX
#
Only Type B and be used.
I/F automatic
selection
# # #
Automatic selection
(all interfaces)
##
X
Automatic selection
(Parallel and USB)
#
X
#
Automatic selection
(Parallel and Type B)
X
##
Automatic selection
(USB and Type B)
Not effective
X X X
Returns to the factory default after the
Reset All is performed or the power is
turned on again.
Table 1-23. Interface Settings
Parallel USB Type B Operations