Service manual

EPSON EPL-5800 Revision B
Product Description Control Panel 29
NOTE:
*1: This item can be selected only when the optional Adobe PS 3 kit is installed.
*2: Cannot be selected / changed by RCP etc. and is not printed on the Status Sheet.
*3: This item can be selected only when the Type B I/F option is installed.
*4: Displayed only when the optional lower cassette unit is installed. Paper sizes are display
only.
*5: LT= default value for Letter-model controller
A4= default value for A4-model controller
*6: Can be set only with the printer driver. Not printed on Status Sheet. Can be to set with
EJL or PJL, but it is valid only when the installed RAM is 64MB or more. (The firmware
does not verify the installed RAM capacity, but the printer driver does. This must not be
stated in the manual.)
*7: Effective only for ESC/Page, PCLXL and PostScript. When other mode is selected, it will
be printed in 600dpi.
*8: Valid for PCL5e, ESC/Page, ESC/P2, FX and 1239X.
*9: When resolution is set to 1200dpi by mode setting, RITech becomes OFF regardless of
this item.
*10: TBD
*11: When this item is changed, reading with EJL and printing on the Status Sheet are
immediately reflected, but become valid after warm boot or at power on again.
*12: Appears only when the optional Type B interface card is installed.
Network card configurations cannot be made from the printer side. Use the utility that
comes with each card.
*13: Display only when Type B Level 3 card is installed. This value cannot be changed and
always set to “No”.
!
Function setting (2)
Config Menu RITech
*9
On, Off
Toner Save Off, On
Density 3, 4, 5, 1, 2
Top Offset -99.0 ~ 0.0 ~ 99.0mm
(0.5mm increments)
Left Offset -99.0 ~ 0.0
~ 99.0mm
(0.5mm increments)
Size Ignore Off, On
Auto Cont Off, On
Page Protect Auto, On
Image Optimum Auto, Off, On
Paper Type
*10
Normal, Thick W, Thick N, Trnsprnc
Setup Menu Time out 0, 5 ~ 60 ~ 300
Standby Continue, Stop
Lang English, Française, Deutsch, ITALIANO,
ESPANOL, SVENSKA, Dansk, Nederl,
SUOMI, Português
Toner E****F, E***
$
F, E**
$$
F, E*
$$$
F,
E
$$$$
F
Toner Out Disable
, Enable
SelecType Unit 0 ~ 99999999
Parallel Menu Parallel I/F
*11
On, Off
Speed Fast, Normal
Bi-D Nibble, ECP, Off
Buffer Size
*11
Normal, Maximum, Minimum
USB Menu USB I/F
*3
On, Off
Buffer Size
*11
Normal, Maximum, Minimum
Table 1-19. Function Setting (1)
Menu Item Value
AUX Menu
*12
AUX I/F
*11
Use, No Use
AUX Config
*13
No, Yes
Buffer Size
*11
Normal, Maximum, Minimum
Table 1-19. Function Setting (1)
Menu Item Value