Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams
Post-SEtUP Procedures
If you have just run SETUP for the first time, you now need to
install the operating system on your computer. See your
operating system manuals for instructions.
You may see an error message and a prompt to run SETUP
when your computer is rebooting if it detects a problem in
your SETUP configuration If so, follow the instructions on
the screen to run SETUP and correct the problem.
You may also see an error message when your computer is
rebooting if you have not installed your operating system on
the hard disk or have not inserted a system diskette in
drive A. If you receive this error message, simply follow the
instructions in your operating system manuals to install the
software on your computer.
After you have installed your operating system, you can install
any software you plan to use. See your application program
manuals for instructions.
If you are going to install Microsoft Windows, be sure to also
install the Windows VGA driver(s) as appropriate for your
monitor. See the VGA Utilities Guide for instructions.
2-30
Running the SETUP Program