Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams

You made changes and want to exit SETUP without
saving the changes
Press
[
You see the following menu:
Save and
Exit
No
Save and
Exit
Return to Setup
Highlight No Save and
Exit
and
press
m
The
computer
does not save any changes you made to your SETUP
options. The computer reboots and tries to
load your operating
system from a diskette or your hard disk drive.
To remain
in the
SETUP
program,
highlight
Return
to
Setup and press
[Enrl
The exit menu disappears and you see
the current SETUP screen.
You saved your settings with
[
You can save your changes and remain
in SETUP by pressing
[no] any time you are using the program. When you press
[nol.
you see a message confirming that your changes are
saved.Ress~toremovetkmessage.
The manner in which you exit SETUP after using the F10
key depends on whether
you made any changes to your
settings after pressing
Fl@
A
If you have made no further changes to your SETUP options
and press
m
to exit SETUP, you see the following menu:
Exit Setup
Return to Setup
2-28
Running the SETUP Program