Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams
You can also disable power-on diagnostic testing of your cache
if you are receiving cache errors that prevent you from using
your computer. This way, you can perform any steps necessary
to diagnose the problem as you obtain technical assistance. (The
default setting for the POD Internal cache test option is
Enabled.)
Note
Neither of the cache options described in this section affect
your system’s
VirtualCachem
feature.
Saving Your Settings and Exiting SETUP
The way in which you exit the SETUP program depends on
whether you have changed the settings of any SETUP options
and whether or not you want to save these changes. For
example, you can do one of the following to exit SETUP:
P
Make no changes and exit
D
Save your changes and exit
0
Not save your changes and exit.
Follow the steps in the appropriate section below to exit
SETUP. If you have just run SETUP for the first time, also be
sure to read "Post-SETUP Procedures" at the end of this
chapter for further instructions on setting up your computer.
2-26
Running the SETUP Program