Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams
3.
Press
[+1
or
I-].
You see a prompt to enter your old
password.
4.
Type your old password and press
I.
The
Password
security Option setting changes to Not installed.
Be sure to save your settings as you exit SETUP to keep your
password security changes. See page 2-26 for instructions.
Setting the Diskette Drive Type(s)
Your system came with at least one diskette drive and you may
have installed another drive of a different size or capacity. The
SETUP program may automatically detect the type(s) of
diskette drive(s) you haveinstalled. Check these settings to
make sure they are correct for your configuration.
0
1.44MB, 3.5-inch
0
1.2MB, 5.25-inch
0
720KB, 3.5-inch
0
360KB, 5.25-inch
Cl
Not installed.
The Number of diskette drives option also displays the
number of drives SETUP detects in your system. See page 2-12
for more information.
Running the SETUP Program
2-19