Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams
Changing a Password
If you need to change the password, follow these steps:
1.
2
3.
4.
5.
6.
If you are already running SETUP, go to step 2.
If you are not running SETUP, follow the instructions at the
beginning of this chapter to start the program.
Highlight the Password option and press
[brl.
The current
setting is
Set.
Press
[nl
You see a prompt to enter your old password.
Type your old password and press
[Mrl.
At the next prompt, type a new password and press
[Mwl
You see a prompt to re-enter your password. Enter your new
passwordagain.
Be sure to save your settings as you exit SETUP to keep your
new password. See page 2-26 for instructions.
Deleting a Password
If you want to delete the password and disable password
security, follow these steps:
1. If you are already running SETUP, go to step 2.
If you are not
running SETUP, follow the instructions at the
beginning of this chapter to start the program.
2.
Highlight the Password security option and press
[Enlwl
The current setting is Installed.
2-18
Running
the
SETUP Program